How to connect the distribution box in parallel

Connecting distribution boxes in parallel requires careful alignment of phase, neutral, and ground lines, proper use of communication cables for inverters, and adherence to safety standards to prevent overloads or short circuits.

Basic Concept

Parallel connection in distribution boxes means linking multiple boxes or circuits so that they share the same supply voltage, allowing multiple loads to be powered simultaneously. This is often done using jumpers or dedicated parallel wiring, but improper jumper connections can be hazardous and are prohibited by standards in many regions ( ).

Step-by-Step Wiring for Parallel Distribution Boxes

1. Identify Input and Output Lines
   • Connect the main supply phase (L) and neutral (N) to the input terminals of the first distribution box.
   • Ensure each subsequent box receives the same phase and neutral lines from the previous box or a common bus.
2. Use Proper Jumpers or Busbars
   • For multiple branch circuit breakers, use dedicated jumpers to connect the top terminals of each breaker in sequence.
   • Avoid connecting multiple wires to a single terminal if it exceeds the rated current, as this can cause overheating ( ).
3. Grounding
   • Connect the ground (PE) terminals of all boxes together using a sufficiently thick ground cable.
   • Ensure the ground is also connected to the main supply ground to maintain safety ( ).
4. Communication and Control Wiring (for inverters or hybrid systems)
   • If using inverters in parallel, connect CAN or RS485 communication cables between units to synchronize operation.
   • Designate one inverter as the Master, and others as Slaves; the master controls load sharing and system monitoring ( ).
   • Ensure the L and N lines of each inverter are correctly connected; never cross L to N between units ( ).
5. Check Ratings and Safety Limits
   • The total load connected should not exceed the algebraic apparent power of the system (typically 90% for backup loads, 60% for RCD-protected loads) ( ).
   • Use a multimeter to verify continuity and correct phase alignment before powering the system.
6. Final Assembly
   • Tighten all screws to the recommended torque (e.g., 1.2–4.0 N·m depending on terminal type).
   • Install covers and ensure no exposed wires remain.
   • Power on the system and verify that all boxes and inverters operate correctly in parallel mode.

Safety Considerations

• Avoid overloading terminals: Each terminal has a maximum current rating.
• Do not mix phases incorrectly: L-to-N misconnection can cause short circuits.
• Follow local electrical codes: Parallel wiring must comply with national standards to prevent hazards ( ).
• Use proper insulation and crimping: Strip wires correctly and use terminals to prevent loose connections ( ). By following these steps, distribution boxes and inverters can be safely connected in parallel, ensuring balanced load distribution, proper grounding, and synchronized operation.