Factory Figure 7-8 POWERVC Fibre Channel Adapter<br />
Figure 7-12 POWERVC Optional Settings The next following panel shown in Figure 7-13 is a summary of the configuration settings for the new POWERVC LPAR. Click Finish on this panel to create the
Factory IBM PowerVC Version 2.0 Introduction and Configuration
The authors of the fourth edition, IBM PowerVC Version 1.3.1 Introduction and Configuration Including IBM Cloud® PowerVC Manager, which was published in September 2016, were Guillermo Corti,
Factory Customizing PowerVC
Configuring Fibre Channel ports View and configure your Fibre Channel ports to restrict certain ports from being used for connectivity types (NPIV, vSCSI, or both) or to restrict them to specific storage
Factory AIX for System Administrators: POWERVM
With NPIV, you can configure the managed system so that multiple logical partitions can access independent physical storage through the same
Factory Fibre Channel switch zoning
If you have multiple (non- Storwize) storage controllers and want to ensure that one target from each controller is zoned, you could use port groups and powervc-config storage fc-zone zone-one-target
Factory Storage connectivity groups
The port must allow connectivity. To verify or change this setting, access the PowerVC user interface and go to Configuration > Fibre Channel Port Configuration. The Connectivity column value cannot
Factory Optional
Create Fibre Channel uplinks Before creating a Fibre Channel uplink, make sure you have configured the universal ports as FC ports using the steps in the previous
Factory Viewing virtual Fibre Channel assignments to a partition
To manually configure virtual Fibre Channel Adapter settings, click Edit Connections. In the Edit connections window, either enter worldwide port name (WWPN) details or select the virtual
Factory IBM PowerVC Version 1.3.2 Introduction and Configuration
Initiator zoning is a mode of Fibre Channel (FC) zoning. With initiator zoning, a zone is created for each initiator and includes all of the controller targets that are supplied by the volume driver in the initiator
Factory Storage connectivity groups
To change the port tag, go to Configuration > Fibre Channel Port Configuration. For NPIV connectivity, the port must have a Fabric value that is contained within the fabric set associated with the storage
Factory IBM Cloud Manager CMO, PowerVC PowerVC, Power 770
This document provides a comprehensive guide for implementing and configuring IBM Cloud Manager with OpenStack on IBM Power Systems Solution Edition for Cloud using the Power
Factory Fibre Channel port assignments
Port selection is governed by the Fibre Channel port configuration and storage connectivity group settings. First, the Fibre Channel port configuration settings are used to find a set of candidate ports
Factory Ibm power vc version 1.2.3 introduction and configuration
This document provides an introduction and overview of IBM PowerVC version 1.2.3, including: - A high-level overview of PowerVC and how it uses OpenStack
Factory Fibre Channel switch zoning
In this situation, PowerVC zones both initiator ports to one target port on each storage controller node. This creates four paths to the storage device and four zones.
Factory Configuring Fibre Channel ports
View and configure your Fibre Channel ports to restrict certain ports from being used for connectivity types (NPIV, vSCSI, or both) or to restrict them to specific storage connectivity groups by using port